Quality control

We have always upholded “The quality is our life”for business goals.Since our company established quality control is the most attention to our production process.And we always keep the high rate of the good products.

At the same time,our company enjoys a high reputation in the northeastern of China.Our quality management system also has been recognized by our many customers who has been visited to our company.

Organization Structure

Our QC team is made up of seven persons and two of them have worked on quality control in Japan.The most experienced member have worked on this job for 10 years.The other members have 3 years experience at least.

Quality Checker

Position

Senior Technician

Staff

Shukui Pan

Skill Level

□CMM □Tool Microscope □Roughness Measurement □Hardness Tester □Digital Caliper □Inside Microscope □Submit Inspection □Test Report Issued By Authority

QC Engineer Profile

QC Engineer Profile
Name		Shugui Pan	Qianli Ma	Xingyang Zhao	Fan Xu	Yubo Zhao	Hongning Shi	Mingzhuo Yu
Photo
Position		Monitor of quality	Engineer of quality	Engineer of quality	Engineer of quality	Quality inspector	Quality inspector	Quality inspector
T E S T I N G O P E R A T I O N I T E M	CMM
	Tool microscope
	Joint arm coordinate measuring machine
	Automatic height gauge
	Hardness tester
	Roughness measuring machine
	Manual height gauge
	Concentricity tester
	Hand-held hardness tester
	Digital caliper
	Orifice calipers
	Caliper depth rule
	Digimatic micrometer
	Inner hole caliper
	Holtest
	Go/no go gage
	Thread ring gage
	Dial gauge
	Gauge block
	Feeler gauge
	Pin Gage
	Inside groove calipers
	Gear tooth micrometer
	Blade micrometer
	Caliper gauge
	Inside calipers
	Inner diameter gauge
	Test tool calibration
	Authoritative test report issued

First confirm all products to be detected and the consistency of drawings.

Second confirm whether product surface adhesion drawing cosmetic requirements.

Third test all the dimensions of the drawing and wire test data on the detection of drawings.

Detect the defective product,the inappropriate content must be written in the list of the “bad repair record sheet”,and on the drawings and products are identified.

Products such as surface treatment,the product must be in the surface treatment area,and make a logo.

write to us

Please send your message to us